Description
Download Manual
- Connects to a 5i25 or 6i25 or 7i92 or 7i92TF with a DB25M – DB25M IEEE cable
- Connects to a 7i92TM directly or with DB25M-DB25F cable.
- Connects to any 7i92T P1 port or to 7i92TH with DB25M-IDC26 cable.
- Use the 3.7″ DIN Rail Mount to mount on standard DIN rail.
- 5 Axis step & direction
- 32 isolated inputs and 16 isolated outputs
- 1 spindle output control with high speed encoder input
The 7I76U is daughter card, breakout board for use with MESA’s 25 pin I/O FPGA cards like the 5I25T, 6I25 and 7I92T. The 7I76U is designed for interfacing up to 5 Axis of step & direction step motor or servo motor drives and also provides a spindle encoder interface, isolated analog spindle speed control and 48 isolated I/O points for general purpose field I/O use. All step and direction outputs are buffered 5V signals that can drive 24 mA. All outputs support differential mode to reduce susceptibility to noise. An isolated analog spindle voltage with direction and enable or forward and reverse outputs is provided for spindle control as is a single spindle encoder channel with TTL or differential inputs. 48 points of isolated field I/O are provided for general control use including limit switch and control panel inputs, coolant enable and tool changer control outputs. Isolated I/O includes 32 sinking inputs and 16 sourcing, sinking, or push-pull outputs. Inputs can sense 5V to 28V signals and the outputs can switch 5V through 28V signals. Maximum output load is 500 mA. Outputs are short circuit protected. In addition to the being able to read digital on/off status of each input, four input pin voltages are readable with 8 bit resolution, and two MPG encoder inputs are provided as an option on four field inputs. Field I/O is powered by an isolated 5-28V field power source. One RS-422 interface is provided for I/O expansion via a serial I/O daughter card. All field wiring is terminated in pluggable 3.5 mm screw terminal blocks.
The 7I76U is a replacement for both the 7I76 and 7I76D and has these additional features:
1. Field outputs can be set to sourcing, sinking, or push pull modes on a per output basis.
2. Field outputs do not require flyback diodes regardless of load current.
3. The digital spindle interface outputs can operate in ENABLE/DIR or FWD/REV modes.
4. The serial expansion interface can operate in both RS-422 and RS-485 modes.
Note: Field power is required (8-32vdc typically 24vdc) for I/O.
Reviews
There are no reviews yet.