7I76

• Connects to a 5i25 or 6i25 or 7i92 or 7i92TF with a DB25M – DB25M IEEE cable
  
• Connects to a 7i92TM directly or with DB25M-DB25F cable.
• Connects to any 7i92T P1 port or to 7i92TH with DB25M-IDC26 cable.
• Use the 3.7″ DIN Rail Mount to mount on standard DIN rail.
  
• 5 Axis step & direction
• 32 isolated inputs and 16 isolated outputs
• 1 spindle output control with high speed encoder input

 All step and direction outputs are buffered 5V signals that can drive 24 mA.  All outputs support differential mode to reduce susceptibility to noise.  An isolated analog spindle voltage with direction and enable outputs is provided for spindle control as is a single spindle encoder channel with TTL or differential inputs.  48 points of isolated field I/O are provided for general control use including limit switch and control panel inputs, coolant enable and tool changer control outputs.  Isolated I/O includes 32 sinking inputs and 16 sourcing outputs.  Inputs can sense 5V to 32V signals and the outputs can switch 5V through 28V signals.  Maximum output load is 300 mA. Outputs are short circuit protected. In addition to the being able to read digital on/off status of each input, four input pin voltages are readable with 8 bit resolution, and two MPG encoder inputs are provided as an option on four field inputs.  Field I/O is powered by an isolated 10-32V field power source.  One RS-422 interface is provided for I/O expansion via a serial I/O daughter card.  All field wiring is terminated in pluggable 3.5 mm screw terminal blocks.

Note: Field power is required (8-32vdc typically 24vdc) for I/O.